Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch untill the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Front Top Cover
Identify the front top cover highlighted in blue
Slide the front top cover in the direction of the arrows marked on the front top cover and Lift the front top cover from the system.
Air Shroud
Identify the air shroud highlighted in blue
Press the release tab on both side of the air shroud.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Cooling fans
Identify the cooling fans highlighted in blue
Hold the orange release tab and lift the cooling fan to disconnect the fan from the connector on the system board.
Cooling fan cage assembly
Identify the cooling fan cage assembly highlighted in blue
Flip out the blue release plunger to unlock the cooling fan cage assembly from the chassis.
Hold the blue release plunger and lift the cooling fan cage assembly away from the system.
Riser 1A assy
Identify the riser 1A Assembly highlighted in blue
Loosen the blue thumb screws on the riser.
Press the blue release tab and holding the blue touch points, lift the expansion card riser from the riser connector on the system board.
Control panel - Right
Identify the control panel highlighted in blue
Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
Remove the screws that secure the right control panel and cable cover to the system.
Unroute the cables from the cable guide.
Holding the right control panel and VGA cable assembly, slide the right control panel out of the system.
Install
Control panel - Right
Identify the control panel location highlighted in blue
Align and slide the right control panel in the slot on the system
Route the right control panel cable through the side wall of the system.
Connect the right control panel cable and VGA cable to the connectors on the system board.
Install the screws that secure the right control panel and the cable cover to the system.
Riser 1A assy
Identify the riser 1A Assembly location highlighted in blue
Holding the blue touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Tighten the blue thumb screw on the riser.
Cooling fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue
Holding the blue release plunger of the cooling fan cage, align the guide rails with the guides on the system.
Lower the cooling fan cage assembly into the system until seated firmly.
Flip in the blue release plunger to lock the cooling fan cage assembly into the system.
Cooling fans
Identify the cooling fans location highlighted in blue
Align and lower the cooling fan into the cooling fan assembly until the fan clicks into place.
Air Shroud
Identify the air shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it clicks into place.
Front Top Cover
Identify the front top cover location highlighted in blue
Slide the front top cover to the front of the system until the front top cover fits into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.